Skip to content

How To Make A Homemade Bird Trap?

Look out the window, take a walk through the park or the streets of the town and you will dare to fly these little birds. You can find these creatures in every country on the planet, except in Antarctica. At a glance, these birds may seem harmless and somewhat charming, but what many do not know is that these birds can be a threat to the country's native birds. For example, let's take the bluebird of North America, where many species of the sky have been reduced to astonishing numbers thanks to birds. These birds tend to survive at higher speeds than other birds and will fight to survive. These birds are not only threatening, but they also have diseases and bacteria that are labelled "winged pets." There are enough reasons to support the proposal to get rid of this bird village, so let's take a look at this guide on how to make a homemade bird traps.

The first step is to take plywood approximately 1/2 inch thick and cut it into saws so that it fits in a size of 18 "x 10" x 5 ". This part becomes the frame of the trap. You must bring a plastic container which can be adapted to the width of the frame. You can cut the container so that it is always cut. After that, take a soft tree, like white pine, and make sure it is 12 "long, 1, 1/4 inch, 3/8 inch thick. Drill a 1/16 inch hole at one end of the tree. Two the hole is easy for the plastic container, and the side with a single hole is for the 35 mm film container. The next step is to drill two 1/8 inch holes in the centre of the plastic container. Place two nails on the side of the board, then prepare a 10-inch square sheet of aluminium and drill two holes so that they protrude: there is another hole in the floor and a washer in the arm, which enters the bird traps Melbourne.

Take the frame just mentioned, drill a hole in the bracket and then place the washers. To make sure the balance beam is in place and creates a door, cut an 18 "x 10" tree and insert the washers and wing nuts. Use the hinge to put the door in place in the trap. Get a table of similar size to the back. Make a suit with a 4-inch diameter PVC pipe, then make a 1/2 hole in the trap to fit the tube.

This step is something you should follow, so be sure to ask them to guide you through steps you know a little about carpentry or with those you are not particularly familiar with. Catching these birds may seem a bit hard and inhuman, but for your health, take the time to think about how they bother and how they think about our environment and our birds.